Central Processor

• 1.5 GHz Intel® Core™ 2 Duo processor L740:-

  • dual-core processor

  • 4 Mbytes of secondary (L2) on-die cache

  • 667 MHz Front Side Bus

• Intel® 64 Technology (64-bit computing)

• uses mFC-BGA 478
  (micro Flip-Chip Ball Grid Array) package

• utilizes Intel® E7520 server class chipset:-

  • uses Intel® 6300ESB I/O Controller Hub

• provision for XDP debug port

SDRAM

• supports 4 Gbytes DDR2-400 ECC SDRAM:-

  • 4 Gbytes soldered on-board

  • up to four bit error correction

  • peak bandwidth of 6.4 Gbytes/s

  • dual channel architecture

• accessible from processor and CompactPCI bus

Mass Storage Interfaces

• 2 x SATA-150 interfaces via J5

• primary channel EIDE interface supports:-

  • 4 Gbytes on-board Flash drive

  • ruggedized versions also support an optional removable Flash drive

• secondary channel EIDE interface supports:-

  • option for removable dual CompactFlash™ carrier or 2.5" ATA100 hard disk drive

  • option uses PMC site 1

Ethernet Interfaces

• 2 x rear interfaces implemented by Intel® 82574L controllers via x1 PCI Express™ links:-

  • support for PICMG 2.16 R1.0 - Packet Switching Backplane (PSB)

• supports 10 Base-T, 100 Base-TX, 1000 Base-T

PMC/XMC Interfaces

• 1 x PMC/XMC site and 1 x PMC site

• common features for both PMC sites:-

  • 32/64-bit, 33/66 MHz PCI/PCI-X operation

  • 3.3V or 5V PCI signaling levels

  • PMC connectors used for rear I/O

  • Front panel I/O available

• XMC (PCI Express™ Mezzanine Card) site interface supported via x8 PCI Express link

Serial Interface

• 1 x RS232 serial channel:-

  • Tx, Rx, RI, CTS, RTS, DSR, DTR and DCD signals via J5

• 16550 compatible UART

Flash EPROM

• 1 Mbyte of BIOS Flash EPROM - 8-bits wide

Firmware Support

• Phoenix® Server BIOS

• comprehensive Power-On Self-Test (POST)

• LAN boot firmware included

Software Support

• support for Linux®,  Windows® XP, Windows®  XP Embedded, Windows® Server 2003, Windows® 2000, QNX®, Solaris™ and VxWorks®

Other Peripheral Interfaces

• PC Real Time Clock (Year 2000 compliant)

• watchdog timer

• 1 x 32-bit Long Duration Timer with processor interrupt capability

• CPU temperature monitor; voltages monitor; optional system fan monitor :-

  • accessible via IPMI

• GPIO signals via J5, two configuration options depending on which AD PP5/004 RTM used:-

  • 5 GPIO signals or

  • 3 GPIO signals and legacy multiplexed I/O signaling e.g. system fan monitor, Ethernet status LEDs on RTM

• 3 x USB 2.0 interfaces accessed via J5

• independent legacy speaker output via J3

CompactPCI Interface

• compliant with PICMG 2.0 R3.0; 3.3V or 5V signaling levels (universal signaling support)

• 33/66 MHz, 32/64-bit interface accessed via J1/J2 connectors

• PCI Express to PCI bridge for off-board accesses

• J4 connector not fitted

• PICMG 2.1 R2.0 Hot Swap compliant

• operates as a System Slot controller or in a Peripheral slot

• option to disable CompactPCI interface (Satellite Mode):-

  • receives power from CompactPCI bus

  • board can be hot swapped

IPMI

• PICMG 2.9 R1.5 (System Management Spec.):-

  • implements the IPMB0 interface

  • implements an IPMB1 interface

• on-board Baseboard Management Controller

• supports 8 Kbytes of non-volatile memory

Electrical Specification

• +5V@3.1A (typical at 1.5 GHz with 4 Gbytes DRAM); +5% / -3%

• +3.3V@5.5A; +5% / -3%

• +12V@0.01A; -12V@0.001A

• +12V and -12V routed to PMC slots

Safety

• PCB (PWB) manufactured with flammability rating of 94V-0

Environmental Specification

• operating temperatures:-

  • 0°C to +55°C (N-Series)

  • -25°C to +70°C (E-Series)

  • -40°C to +85°C (K-Series)

• storage temperature: -40°C to +85°C

• 5% to 95% Relative Humidity, non condensing (operating or storage):-

  • K-Series includes humidity sealant

• ruggedized versions - see separate datasheets:-

  • rear plug compatible

  • conduction-cooled: PP 452/03x-RC (available)

  • air-cooled: PP 452/03x-RA (planned)

Mechanical Specification

• 6U form-factor: 9.2inches x 6.3inches (233mm x 160mm)

• single-slot: 0.8inches (20.3mm)

• connectors: IEC-1076-4-101 for J1-J5

• shock: 20g, 11ms, ½ sine (operating);
  30g, 11ms, ½ sine (non-operating)

• vibration: 5Hz-2000Hz at 2g, 0.38mm peak displacement (operating); 5Hz-2000Hz at 5g, 0.76mm peak displacement (non-operating)