PP PMC/202-U - Dual PMC Carrier Board
The PP PMC/202 PMC carrier board provides a flexible solution for designers wishing to add functionality to 32/64-bit (33/66 MHz) CompactPCI® systems using PMC modules. The carrier can accommodate two single or one dual width, 32/64-bit (33/66 MHz), PMC modules conforming to the IEEE 1386 Common Mezzanine Card standard. A wide range of commercial and proprietary designed PMC modules can be supported such as SCSI, LAN, WAN, Graphics and Communications Controllers. Hot Swap support enables live insertion and extraction of the PP PMC/202 so that I/O and network interfaces can be added, replaced or upgraded without interruption to the system operation. I/O signals from each of the PMC sites are routed to the CompactPCI J3 and J4 or J5 connectors allowing access from the rear of the system. Front panel access is supported and there is an optional rear panel I/O Transition Module.
Features
- Supports 2 single size PMC modules or one dual width
module:
- 5 Volt or 3.3 Volt signaling
- 32/64-bit and 33/66 MHz
- 5 Volt or 3.3 Volt signaling
- "Hot Swap” live insertion and extraction
- I/O via front panel and rear I/O via J3 and J4 or J5
connectors:
- rear I/O routed as differential pairs
- rear I/O routed as differential pairs
- 3.3 Volt, 5 Volt, +12 Volt and -12 Volt provided for
PMC modules via CPCI backplane
- Extended temperature versions available:
- -25°C to +70°C (E-Series)
- -25°C to +70°C (E-Series)
- Occupies one 6U CompactPCI slot:
- 5 Volt or 3.3 Volt signaling
- 32/64-bit and 33/66 MHz
- 5 Volt or 3.3 Volt signaling
