Specification Sheet: PP PMC/202

- Dual PMC Carrier Board

PMC (PCI MEZZANINE CARD) INTERFACES

• support for 2 single width modules or one dual width module:-

  • 5 Volt or 3.3 Volt signaling

  • 32/64-bit and 33/66 MHz PCI interface

  • supports dual function modules

  • supports non-Monarch Processor PMC modules

• complies with CMC (Common Mezzanine Card) standard IEEE 1386-2001 and PMC (PCI Mezzanine Card) standard IEEE 1386.1-2001

• I/O can be accessed via front panel

• I/O can also be accessed via rear through backplane connectors:-

  • 64 I/O signals per PMC site

  • PMC rear I/O connects via J3 and J4 or J3 and J5

  • PMC rear I/O routed as differential pairs to support SCSI rear I/O

  • can connect to a Transition Module (AD PP2/001)

• logical layer based on PCI protocol specification

• electrical layer based on PCI electrical specification

HOT SWAP FUNCTION

• permits live insertion and extraction of PP PMC/202 carrier

• supports Basic and Full Hot Swap

• compatible with PICMG^® 2.1, Rev 2.0 Hot Swap specification

• Hot Swap capable register:-

  • insertion

  • extraction

  • ENUM  mask/enable

  • front panel blue LED

• CPCI backplane interface signals:-

  • ENUM (board insertion/extraction indication)

  • healthy (power)

COMPACTPCI BUS INTERFACE

• conforms to PICMG 2.0 R3.0:-

  • supports 3.3V and 5V signaling

  • 32/64-bits at 33/66MHz

• PLX Technology PCI 6254 PCI to PCI bridge

OTHER FEATURES

• front panel activity LED:-

  • flashes with on-board PCI bus activity

• front panel fault LED:-

  • reports power fault or PCI bus error conditions

ELECTRICAL SPECIFICATION

• +5V@0.2A; +5% / -3%

• +3.3V@0.6A; +5% / -3%

• +12V@0.03A;

• -12V@0.01A (0.0A if no PMC module requires -12V)

ENVIRONMENTAL SPECIFICATION

• operating temperatures:-

  • 0°C to +55°C (N-Series)

  • -25°C to +70°C (E-Series)

• 10% to 95% Relative Humidity (operating)

• -40°C to +70°C (storage)

• 10% to 95% Relative Humidity (storage)

SAFETY

• PCB (PWB) manufactured with flammability rating of 94V-0

MECHANICAL SPECIFICATION

• 6U form-factor: 9.2” x 6.3” (233.4mm x 160mm)

• utilizes a single CPCI slot: 0.8” (20.3mm)

• connectors: IEC-1076-4-101 for J1, J2, J3, J4, J5 (not all fitted)

• shock:

  • 20g, 11ms, ½ sine (operating);

  • 30g, 11ms, ½ sine (non-operating)

• vibration: 

  • 5Hz-2000Hz at 2g, 0.38mm peak displacement (operating);

  • 5Hz-2000Hz at 5g, 0.76mm peak displacement
    (non-operating)