Specification Sheet: XM 510/x24
Quad Port 10/100/1000 Ethernet XMC Adaptor
(click to view Ruggedized Air-Cooled or Ruggedized Conduction-Cooled)
Gigabit Ethernet Interfaces
- 4 x 1000Base-T/100Base-Tx/10Base-T
- factory build options for:-
- 4 x Ethernet via PMC P4 or XMC P6 connector or
- 4 x RJ45 connectors on front panel
- implemented by 2 x Intel® 82575EB Gigabit Ethernet controllers:-
- supports IEEE 802.3ab for 1000Base-T over Category 5/5e UTP (Unshielded Twisted Pair) Cable
- supports IEEE 802.3/802.3u for 10Base-T/100Base-Tx over Category 5 UTP cable
- supports Jumbo frames
- individual MAC and frame Controllers supporting the following features:-
- 8 Kbyte transmit and receive FIFOs for each port
- 48 Kbyte per-port packet buffer
- transmit and receive IP, TCP and UDP checksum off-loading
- transmit TCP segmentation
- automatic retransmission
- automatic receive stripping and transmit padding (individually programmable)
- automatic runt frame rejection
- physical interfaces (PHY) implemented by the Intel 82575EB devices internally supporting:-
- 1000Base-T/100Base-Tx/10Base-T auto-negotiation
- automatic polarity and MDI/MDI-X selection
- full and half duplex operation
- status LEDs, front or rear (none on PMC rear I/O variants)
XMC Interface
- complies with PCI Express Protocol Specification 2.0 including:-
- x4 PCI Express® interface
- trains down to x2 or x1
- PCI Express switch provides expansion from single x4 port to 2 x4 ports connecting to the Ethernet controllers
BIOS EPROM
- 8-bit wide 128 Kbyte SPI Flash EPROM with PXE BIOS Firmware:-
- one per Ethernet controller
- in-circuit programmable
Software
- support for Linux®, VxWorks®, Windows® 2000, Windows® XP, Windows® XP Embedded and QNX®
Electrical Specification
- +5V@2.0A ±5% (typical with quad 1000Base-T operating)
- +12v@0.8A ±5% (typical with quad 1000Base-T operating)
- 3.3V and -12V not utilized
Environmental Specification
- compatible with XMC host boards operating at:-
- 0°C to +55°C (N-Series)
- -25°C to +70°C (E-Series)
- -40°C to +85°C (K-Series)
- 5% to 95% Relative Humidity, non-condensing (operating):-
- K-Series includes humidity sealant
- -40°C to +85°C (storage)
- 5% to 95% Relative Humidity, non-condensing (storage)
- ruggedized air-cooled and ruggedized conduction-cooled versions planned
Mechanical Specification
- single size CMC (Common Mezzanine Card) 74mm x 149mm
- 10mm height stack module