Specification Sheet: AD PP2/001

- Rear Panel I/O Transition Module for CompactPCI^®

ETHERNET INTERFACE

• supports 10BaseT and 100BaseTx for UTP CAT5 via RJ45 connector on Transition Module’s front panel
• MII (Media Independent Interface) is provided on PIM A for other Ethernet interfaces (PIM is a PMC Interface Module)

EIDE INTERFACE

• supports Ultra-DMA 33 interface via 40-way header
• on board CompactFlash^® socket

SERIAL INTERFACES

• 9-way D type connector for COM2 via Transition Module’s front panel
• COM1 and COM2 accessed via PIM B

USB INTERFACES

• USB0 is accessed via TM’s front panel
• USB1 is accessed via PIM B

PARALLEL PRINTER PORT

• accessed via PIM A

FLOPPY DISK INTERFACE

• accessed via 34-way header on Transition Module

OTHER INTERFACES

• PC speaker, external battery and power status via 10-way header
• general purpose I/O including a relay output via 14-way header on Transition Module
• 6 user definable status switches
• keyboard and mouse accessed via 10-way header on Transition Module or via PIM B

ELECTRICAL SPECIFICATION (no CompactFlash Module)

• all voltages to be within ±5%
• +5V@0.2A; +3.3V@0.01A; +12V@0.0A; -12V@0.0A with no active PIMs
• add 0.1A (typical) at 5V for CompactFlash^®  or 0.33A for IBM^® Microdrive™

ENVIRONMENTAL SPECIFICATION

• 0°C to +55°C (operating); -40°C to +70°C (storage)
• 10% to 90% Relative Humidity (operating)
• 10% to 90% Relative Humidity (storage)

MECHANICAL SPECIFICATION

• 6U form-factor: 9.2" x 3.2" (233.35mm x 80 mm)
• single-slot: 4HP 0.8" (20.3mm)
• connectors: IEC-1076-4-101 for J3, J4 and J5
• shock: 5g/6ms
• vibration: 1g (5Hz to 500Hz)