Specification Sheet: AD PP5/001

- Rear Panel I/O Transition Module for CompactPCI^®

ETHERNET INTERFACE

• two channels

• supports 10BaseT,100BaseTx and 1000BaseT for UTP CAT5 via RJ45 connectors on front panel

• Ethernet signals are routed via transition module’s front panel or via PICMG® 2.16 Packet Switching Backplane

EIDE INTERFACE

SERIAL INTERFACE

• RJ45 connectors for 2 x RS232 asynchronous serial ports:-

  • each channel supports TXD, RXD, RTS, CTS, DTR, DSR and DCD

• controlled via Low Pin Count (LPC) bus

USB INTERFACE

• 1 x USB channel accessed via USB connector on front panel

PARALLEL PRINTER PORT

• via 26-way header on-board

• supports all common modes of operation
  (for example, EPP, ECP)

• controlled via LPC bus

FLOPPY DISK INTERFACE

• via 34-way header on board

• controlled via LPC bus

PMC I/O

• 2 x 68-way high density D-type connectors on the front panel

• Vertical on-board 68-way high density D-type connector

• each connector provides 64-bits of I/O from one PMC site

• wiring compatible with Concurrent Technologies PMC SCSI modules

OTHER INTERFACES

• PC speaker via 5-way header

• 10-way header providing:-

  • system fan monitor

  • external reset

  • general purpose user I/O lines (GP I/O)

ELECTRICAL SPECIFICATION

• all voltages to be within ±5%

• +5V@0.2A - quiescent current; +3.3V@0.2A

ENVIRONMENTAL SPECIFICATION

•  0°C to +55°C (operating)

•  -40°C to +70°C (storage)

• 10% to 90% Relative Humidity, non-condensing (operating)

• 10% to 90% Relative Humidity, non-condensing (storage)

MECHANICAL SPECIFICATION

• 6U form-factor: 9.2" x 3.2" (233.35mm x 80mm)

• single-slot: 0.8" (20.3mm)

• connectors: IEC-1076-4-101 for J3 and J5

• shock:

  • 20g, 11ms, ½ sine (operating);

  • 30g, 11ms, ½ sine (non-operating)

• vibration: 

  • 5Hz-2000Hz at 2g, 0.38mm peak displacement (operating);

  • 5Hz-2000Hz at 5g, 0.76mm peak displacement (non-operating)