- Dual 2.4 GHz or 2.0GHz Low Voltage Intel^® Xeon^™ processor based CompactPCI Board

CENTRAL PROCESSORS

• dual 2.4 GHz or dual 2.0 GHz Low Voltage Intel® Xeon™ processors

• each processor:-

  • internal (L1) on-die cache

  • 512 Kbytes of secondary (L2) on-die cache

  • hyper-threading technology

  • NetBurst™ Microarchitecture

  • no CPU fan required

• utilizes 64-bit ServerWorks’ GC-LE chipset:-

  • 2.4 GHz processor supports 533 MHz processor bus to give peak bandwidth of 4.2 Gbytes/s

  • 2.0 GHz processor supports 400 MHz processor bus to give peak bandwidth of 3.2 Gbytes/s

DRAM

• supporting up to 4 Gbytes of DDR ECC SDRAM:-

  • up to 4 Gbytes provided  via two 184-pin DIMM sockets

  • DIMM modules fitted in pairs

  • error correction up to 4-bits

  • peak bandwidth matches processor bus

• accessible from Xeon processor or CompactPCI bus

HARD DISK INTERFACES

• EIDE interface:-

  • supports up to Ultra-DMA 100 for high performance drives

  • 2 x channels (primary and secondary)

  • secondary channel can be used for on-board 2.5 inch disk drive and/or support for 1 x CompactFlash™ or Microdrive™ Type II drive. Note : 2.5 inch disk drive occupies the PMC site

  • primary channel is accessible via J5 to the Transition Module

• Ultra 160 SCSI:-

  • implemented by a LSI53C1000R controller via 64-bit/66 MHz PCI bus

  • accessible via J3 to the Transition Module

ETHERNET INTERFACES

• 2 x channels supporting 10Base-T, 100Base-TX, 1000Base-T

• implemented by Intel® 82546GB LAN Controller via 64-bit/66 MHz PCI bus

• support for PICMG 2.16 - Packet Switching Backplane (PSB)

•  both channels available via J3:-

  • one channel is switchable between front panel RJ45 connector and J3

• optional support for rear panel RJ45’s via the Transition Module

GRAPHICS INTERFACE

• implemented by a Silicon Motion SM722 providing:-

  • 8 Mbytes video memory

  • resolutions up to 1280 x 1024; supporting up to 16M colors

• analog interface via front panel connector

• DVI-D flat panel interface supported via J3 to the Transition Module 

PMC (PCI MEZZANINE CARD) INTERFACE

• 1 x PMC slot with I/O via front panel:-

  • 3.3V signaling

  • supports 32/64-bit, 33/66 MHz PCI operation

SERIAL INTERFACE

• 2 x RS232 serial channels

• 16550 compatible UART

• both accessed via J5 to the Transition Module and one accessed via front panel

• each channel supports CTS, RTS, RI, DSR, DTR and DCD

FLASH EPROMs

• 512 Kbytes of BIOS Flash EPROM - 8-bits wide

SOFTWARE SUPPORT

• support for Linux^®, Windows Server 2003™, Windows^® XP, Windows^® 2000, Windows NT^®, VxWorks^®,  and QNX^®

OTHER PERIPHERAL INTERFACES

• keyboard and mouse interfaces, sharing a single PS/2™ type connector on front panel or via J5 to the Transition Module

• PC-compatible Real Time Clock (Year-2000 compliant)

• floppy disk interface via J5 to the Transition Module

• 2 x USB (Universal Serial Bus) interfaces accessed via J5 to the  Transition Module

• parallel printer port interface (ECP, EPP and IEEE1284) via J5 to the Transition Module

• watchdog timer

• system fan monitor; two CPU temperature monitors; voltages monitor; board temperature monitor:-

  • all accessible via IPMI

• legacy speaker interface

FIRMWARE SUPPORT

• Phoenix^® ServerBIOS^™

• comprehensive Power-On Self-Test (POST)

• LAN boot firmware included

COMPACTPCI INTERFACE

• compliant with PICMG 2.0 R3.0; 3.3V and 5V signaling levels:-

  • universal signaling supported

• 33/66 MHz; 32/64-bit interface accessed via J1/J2 connectors

• utilizing a PCI-PCI bridge for off-board accesses

• PICMG 2.1 R2.0 Hot Swap Specification Compatible as hot swap controller only

•  J4 connector not fitted

• operates as a System Slot controller or in a peripheral slot

• option to disable CompactPCI interface (Satellite Mode):-

  • use in any slot

  • receives power from CompactPCI bus

  • board can be hot swapped in this mode

IPMI (INTELLIGENT PLATFORM MANAGEMENT INTERFACE)

• PICMG 2.9 R1.0 (System Management Specification)

• implements the IPMB0 interface

• on-board Baseboard Management Controller

• supports 32 Kbytes of non-volatile memory

ELECTRICAL SPECIFICATION

• +5V@16A (typical with dual 2.0 GHz CPU and 2 Gbytes DRAM); +5% / -3%

• +3.3V@8A; +5% / -3%

• +12V@0.0A; -12V@0.0A

• +12V and -12V routed to PMC expansion slot

SAFETY

• PCB (PWB) manufactured with flammability rating of 94V-0

ENVIRONMENTAL SPECIFICATION

• 0°C to +55°C (operating)

• 10% to 90% Relative Humidity (operating non condensing)

• -40°C to +70°C (storage)

• 10% to 90% Relative Humidity (storage non-condensing)

MECHANICAL SPECIFICATION

• 6U form-factor: 9.2inches x 6.3inches (233mm x 160mm)

• requires left hand system slot

• dual slot: 1.6 inches (40.6mm)

• connectors: IEC-1076-4-101 for J1-J5

• shock:

  • 20g, 11ms, ½ sine (operating);

  • 30g, 11ms, ½ sine (non-operating)

• vibration:

  • 5Hz-2000Hz at 2g, 0.38mm peak displacement (operating);

  • 5Hz-2000Hz at 5g, 0.76mm peak displacement (non-operating)